heckofagator
Well-Known Member
Need to get my new Foundry wired up. I have been looking at GFCI breakers for my panel and apparently the GFCI breaker is about $140.
https://www.amazon.com/gp/product/B00ECKLKBM/ref=ox_sc_act_title_1?smid=A1QRT0RAXAWMKI&psc=1
Panel is Eaton CH type. I see there are also inline GFCI's which may be a bit cheaper. Just wondering if there's a preferred way to go? I also saw mention of a spa subpanel, but those seemed to be over $100, so I'm not sure that buys be a whole lot of $$ savings going that way.
FWIW, I was planning on a 30amp 240v circuit with L6-30r near the panel and then I'll need to make an extension cord from the Anvil 6-15p to the new L6-30r. I hope no issues with that.....
https://www.amazon.com/gp/product/B00ECKLKBM/ref=ox_sc_act_title_1?smid=A1QRT0RAXAWMKI&psc=1
Panel is Eaton CH type. I see there are also inline GFCI's which may be a bit cheaper. Just wondering if there's a preferred way to go? I also saw mention of a spa subpanel, but those seemed to be over $100, so I'm not sure that buys be a whole lot of $$ savings going that way.
FWIW, I was planning on a 30amp 240v circuit with L6-30r near the panel and then I'll need to make an extension cord from the Anvil 6-15p to the new L6-30r. I hope no issues with that.....