I bought the FTSS which comes with the coil on the lid. I removed the coil and installed on the side. I don’t think they will just sell the coil but you can see if they will.
Willing but I think the cost could exceed the kettle cost. I priced out UPS to PA and it ranged from $166-329. If you can find a cheaper option, it's 40 pounds and box would be 24X24X24
20 gallon SSBrewtech kettle
5500w 240v stainless heating element
Whirlpool valve
Trub dam on pickup valve
Neoprene insulation
Silicone mat to insulate from table
Additional port at the top for BIAB recirculation or steam condenser
Great kettle for brew in a bag but also could be a HERMS HLT or...
Well cared for Grainfather Connect with $150 in extras.
If you've been looking for an all-in-one unit, I'd like to pass this on to you.
Extras include:
+ Camlock conversion (40$) value)
+ Graincoat (50$ value)
+ Dolly so you can roll it around (25$ value)
+ Overflow filter (10$ value)
+...
I’d like to make a feature request. Either put a 1.5” TC port on the 4” cap and chiller coil or drill and tap them so the PRV is permanently installed. Make the PRV a non-optional accessory. Thanks @SpikeBrewing
I am going to use the Blichmann TC spunding valve on the 1.5” TC port. Where would you recommend locating the PRV? How about a tee on the 1.5” TC port with the PRV on the top and the spunding on the side? Other option I considered is permanently installing on the cooling coil cap. Thanks...